Audio Selector Enclosure for 3.5 mm Jacks (November 15, 2026)
English Français
Antre du Tryphon
Search

3D Printing

388 posts · Show all posts

Prusa i3 Bed Cable Guide

Prusa i3 Bed Cable Guide

December 15, 2013 · claude 3D Printing
Based on Prusa i3 heated build platform cable strain relief clip, this cable guide is smaller and does not exceed the bed by more than 5 mm. It also has a hole for the zip tie.

Misan’s Another Compact Extruder Fan Holder

Misan’s Another Compact Extruder Fan Holder

December 8, 2013 · claude 3D Printing
This is a simple 40 mm fan holder for Misan's Another Compact Extruder. Used with half fan mount, it cools off the J-HEAD preventing the filament from melting in the upper part of it.

Unclogging A 3D Print Head

Unclogging A 3D Print Head

July 29, 2013 · claude 3D Printing
Unclogging a 3D print head is not always an easy task, especially when you lack of the proper tools. They are sometimes hard to find. To unclog a .35mm J-Head fitted for 1.75 mm filament, I am using a strand of a steel cable and a stake flag. The...

3D Printing Supply Estimator

3D Printing Supply Estimator

June 8, 2013 · claude 3D Printing GCode
A GCode Analyzer for 3D printing is now available. This on-line tool estimates the amount of filaments required and the cost to print a 3D object. Give the filament type, customize some parameters if needed and upload the GCode files. Dual extrusion...

Preventing warping when printing 3D ABS objects

Preventing warping when printing 3D ABS objects

February 16, 2013 · claude 3D Printing Prusa Mendel ABS
The biggest issue when printing 3D ABS objects is warping. As an example, this 8 cm x 8 cm bit holder is badly warped. In this example, 5 mm. !](http://www.ctheroux.com/uploads/2013/02/dremel-bit-holder-warpage.jpg) Adding disks (1.5 cm x 1 mm) at...

Cannot reach 110 Celsius with a Prusa PCB Heated Bed Mk 1

Cannot reach 110 Celsius with a Prusa PCB Heated Bed Mk 1

December 2, 2012 · claude 3D Printing Prusa Mendel
I was not able to reach 110 Celsius with a Prusa PCB Header Bed MK1. My initial installation was with the PCB traces down with a borosilicate glass on top of it. I found out that installing it with the traces up as show below resolved the issue....

G-Code commands supported by Marlin

G-Code commands supported by Marlin

November 29, 2012 · claude 3D Printing GCode Marlin
The G-Code commands supported by Marlin 3D printing firmware are:

Building a Prusa Mendel Iteration 2 3D Printer

Building a Prusa Mendel Iteration 2 3D Printer

October 4, 2012 · claude 3D Printing
It is not obvious to choose and get a 3D printer. There is quite a lot a choices on the market which can be divided in two categories: pre-assembled and kits. Pre-assembled printers are expensive. Kits can be a quite a challenge to assemble as per...