3D Printing

Tape Roll Holder Revisited

April 11, 2014 · claude 3D Printing

This is a simple holder for a Tape Roll. This design is much more robust than the previous one (Tape Roll Holder). You simply need to screw it to a vertical surface. You can use it for other purposes obviously.

Mounting plate for Arduino UNO/Duemilanove/Diecimila

April 6, 2014 · claude Arduino 3D Printing

A simple mounting plate for the Arduino UNO, Duemilavone, Diecimila, Freeduino or any other compatible boards. Use #4-40 screws to mount the board on the mounting plate.

40 MM Angle Bracket With Adjustable Foot

March 10, 2014 · claude 3D Printing

This is an adjustable foot for 40 mm T-Slot aluminium extrusion combined with a 90 degree bracket. It was design, especially for a 3D printer. It can serve other purposes obviously. You will likely need 4 feet and 4 angle brackets. Furthermore, you...

40 MM T-Slot Adjustable Foot

March 7, 2014 · claude 3D Printing

This is an adjustable foot for 40 mm T-Slot aluminium extrusion. It was design, especially for a 3D printer. It can serve other purposes obviously. You will likely need 4 feet, 2 right and 2 left supports. Furthermore, you will need four threaded...

40 MM T-Slot Angle Bracket

March 4, 2014 · claude 3D Printing

40 mm T-Slot Angle Bracket.

20 MM T-Slot End Caps

March 4, 2014 · claude 3D Printing

20 mm x 20 mm, 20 mm x 40 mm and 20 mm x 60 mm T-Slot end caps.

Lexar USB Stick Case

February 23, 2014 · claude 3D Printing

Replacement for a Lexar USB Stick case. Cut off the support material after printing the main part of the case. Lexar's USB stick can be open easily by prying it on the side with a knife.