Preventing warping when printing 3D ABS objects
English · Français
February 16, 2013
Antre du Tryphon
Search
Preventing warping when printing 3D ABS objects

Preventing warping when printing 3D ABS objects

February 16, 2013 · claude 3D Printing Prusa Mendel ABS
The biggest issue when printing 3D ABS objects is warping. As an example, this 8 cm x 8 cm bit holder is badly warped. In this example, 5 mm. !](http://www.ctheroux.com/uploads/2013/02/dremel-bit-holder-warpage.jpg) Adding disks (1.5 cm x 1 mm) at...
Read More
Cannot reach 110 Celsius with a Prusa PCB Heated Bed Mk 1

Cannot reach 110 Celsius with a Prusa PCB Heated Bed Mk 1

December 2, 2012 · claude 3D Printing Prusa Mendel
I was not able to reach 110 Celsius with a Prusa PCB Header Bed MK1. My initial installation was with the PCB traces down with a borosilicate glass on top of it. I found out that installing it with the traces up as show below resolved the issue....
Read More

Tags