Object

Waveshare Pi Pico Dual Expander Base Plate

April 10, 2021 · claude 3D Printing

This is a baseplate for the Waveshare Pi Pico Dual Expander. You will need 4 tiny screws to mount it. An infill of 15% is recommended. Support is not needed.

1802 Membership Card Stand

February 26, 2021 · claude 3D Printing

This is a simple stand for the 1802 (COSMAC ELF) Membership Card. The 1802 is a vintage micro-processor. You can get this kit at http://www.sunrise-ev.com/1802.htm . I'm not affiliated with the seller in anyway. I bought the kit.

LG 27EA33 Storage Trays

February 21, 2021 · claude 3D Printing

This is a tray designed to be installed on the stand of an LG 27EA33 monitor. You need to print the STL file provided and the same file mirrored. You will then need to glue them together.

Panavise 303 replacement pads

January 24, 2021 · claude 3D Printing

These are replacement pads for the Panavise 303 vise. It has groves to hold tubular objects. I've printed it in semi-flexible filament, but works fine printed in PLA.

SBC Server Case

December 28, 2020 · claude 3D Printing

This is a modular SBC or Development Board enclosure. Its base design principle is you stack on top of each other plates that hold various devices such as Raspberry PI, Arduinos, ESP32, hard drives, etc. You can customize it the way you like. You may...

3.5 inch Hard Drive Box

November 8, 2020 · claude 3D Printing

This is a box for a 3.5 inch hard drive and its cover. It was specifically designed to fit in a small safety box often rented by banks.

Electronic Bench Organizer

October 31, 2020 · claude 3D Printing

This is an organizer especially designed for an electronic bench to hold small parts, screws, etc.

Magazine File

October 24, 2020 · claude 3D Printing

This is a magazine file 60 mm wide. It is designed for letter size paper. It is by design a bit smaller than the document it holds. It has holes to mount it on the side of a desk.

CR-10 Under Bed Tray

October 18, 2020 · claude 3D Printing

These are trays to put under a CR-10 3D printer. The separator of one tray are 15 mm in height. For the other one, 38 mm in height which is the total height of the tray. The overall size of both trays are the same.

Hanging Open Box

October 11, 2020 · claude 3D Printing

This is an open box that can be hanged using 2 screws. The diameter of the head of the screw must be less than 1 cm. Its dimensions are 100 mm wide, 100 mm in height and 60 mm depth.

Tags