Object

Wera Micro Screwdriver Stackable Tray

October 23, 2021 · claude 3D Printing

This is a tray that holds up to 8 Wera micro screwdrivers. The design will hold the screwdriver labels upright. Multiple trays may be stacked. Support material is required for the corners. An infill of 20% is recommended.

Micro SD Card Carrier

September 25, 2021 · claude 3D Printing

This object is a simple micro SD card carrier having the same size as an SD card. It was designed to put a micro SD card into a SD card case that contains sleeves.

Raspberry PI Case 1B+/2/3

September 11, 2021 · claude 3D Printing

This is a minimalist case for a Raspberry Pi 1B+, 2 or 3. Why another case when there are so many out there? This one has the smallest footprint. Most important, it has a 7 mm clearance between the bottom of the case and the Raspberry Pi. 2 mounting...

DIN Rail Prototyping Stand V02

August 28, 2021 · claude 3D Printing

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also provided to tilt a bit the stand (15 degrees). You will find on Thingiverse or Printables...

Waveshare Pi Pico Quad Expander Base Plate

August 14, 2021 · claude 3D Printing

This is a baseplate for the Waveshare Pi Pico Quad Expander. You will need 4 or more tiny screws to mount it. An infill of 15% is recommended. Support is not needed.

Coaster Set

July 25, 2021 · claude 3D Printing

This is a coaster set. This design limits the contact surface between the recipient and the coaster. The deep design prevents the condensation waters from touching the recipient.

TronXY X5SA Z Cable Chain Holder

June 12, 2021 · claude 3D Printing

This is a replacement of the stock Z Axis Cable Chain Holder of the TronXY X5SA. The straight design is inappropriate because of the nuts on the extrusion side. I have design one that works perfectly.

DIN Rail Prototyping Stand

May 23, 2021 · claude 3D Printing

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. In the picture, the bottom part of the stand is 20 mm higher than the height in the supplied STL file....

4 Digits Nixie Tube Clock Stand

April 25, 2021 · claude 3D Printing

This is a 15 mm in height stand for a 4 Digits Nixie Tube Clock. This clock is available on AliExpress. The base of the clock is 40 mm x 111 mm.

Another Pen Holder

April 17, 2021 · claude 3D Printing

This is a pen holder of an unusual design. Three sizes are available. You can increase the capacity of them by gluing another one on its side.

Tags