Object

CR-10 X-axis Height Adjustment Tool

October 29, 2017 · claude 3D Printing

This is a X axis height adjustment tool designed for the CR-10, especially if the Z axis upgrade is installed. Nevertheless, it can be certainly used for other 3D printers. You need to print two tools to use it.

Mini and Half Breadboard Mounting Plates

October 28, 2017 · claude 3D Printing

These are mounting plates for the mini and half size breadboards. Sometimes, I use a breadboard temporarily for a project. It is messy to remove it if it was sticked to a component of the project using the double sided tape underneath it. Also, it is...

Classic Arduino Mouning Plate

October 22, 2017 · claude 3D Printing

This is a mounting plate for the classic Arduino's Duemilanove/Diecimila/NG/Uno and any other ones that has the same form factor. This mounting plate serves three purposes:

L298D Motor Driver Mouning Plate

October 22, 2017 · claude 3D Printing

This is a mounting plate for the dual motors driver board that uses a L298D. They are widely available. This mounting plate serves three purposes:

CR-10 X-Axis Led Strip Holder

October 15, 2017 · claude 3D Printing

This is a led strip holder that latches in the X axis extrusion slot of a CR-10 3D printer. You attach a led strip to the bottom to light up the bed while printing an object. This is a remix of http://www.thingiverse.com/thing:2252158. I removed the...

Logitech C170 Privacy Shield

October 9, 2017 · claude 3D Printing

This is a privacy shield that you put on your Logitech C170 webcam in order to block the lens and thus to ensure your privacy.

Sturdy Cable Holder

October 9, 2017 · claude 3D Printing

This is a simple robust cable holder. Why robust? The other ones I designed were too weak. With time, they were bending from the weight of the cables. With 8 slots, its overall size is about 15 cm (W) x 4 cm (D) x 2.5 cm (H) or 6" (W) x 1"1/2 (D) x...

Wall Mounted Pen Cup

July 30, 2017 · claude 3D Printing

This is a simple pen cup that can be mounted to a wall. It is divided into three compartments of equal sizes. Its size is about 14 cm (W) x 6 cm (D) x 87 cm (H). The distance between the mounting holes is 10 cm.

Suspended Glass For Photography - 1-1/4 Inch Pipe Foot

May 15, 2017 · claude 3D Printing

This model can be used for many purposes. Nevertheless, it was mainly designed to suspend a sheet of glass in the air. This setup is used to take pictures of small objects without shadows. This object is designed for standard 1-1/4 inch abs drain...

Rigid 18V Vacuum Nozzle

May 15, 2017 · claude 3D Printing

This is a simple wide nozzle for a Rigid Gen5X Brushless 18V Wet/Dry Vacuum. The internal diameter is about 31.5 mm or 1-1/4 inch.

Tags