Antre du Tryphon

Arduino EEPROM dump utility class

March 2, 2024 · claude Arduino Hardware IoT +1

An Arduino EEPROM dump utility class have been added to the repository

Arduino UNO R4 Wi-Fi password connection issues

March 2, 2024 · claude WiFI Arduino Hardware +4

The Arduino UNO R4 Wi-Fi is a great addition to the Arduino family. A fun little board to play with.

TIL311 test program

January 22, 2022 · claude Arduino Hardware Electronic Component

TIL311 are single-digits LED hexadecimal displays with an internal four-bit latch and decoder along with the LED drivers. They come in 14 pins, dual-in-line-package. The characters are made of an 4 x 7 array of red LEDs.

Maximum frequency an Arduino can generate

September 7, 2015 · claude Arduino

What is the maximum frequency an Arduino can generate? Typically, I obtained a frequency of less than 100 kHz using the Arduino function calls. The results were lower than I expected. I also observed that I had a frequency higher by 25 kHz using a...

STM32 Minimum System Development Board

July 20, 2015 · claude Arduino STM32

This post describes how to upload code to a STM32 Minimum System Development Board that can be bought from Ali Express or eBay for around $4.00 US. You will be able to compile and upload a led blinking program to the board at the end of this guide....

An Arduino library for the MAX7219 Led Display Driver.

July 20, 2014 · claude Arduino

The MAX7219 chip does a wonderful job when its time to drive either a 64 led matrix or an eight digit (seven segments) display. Only three wires are required: a chip select (CS), a data in (DIN) and a clock (CLK). The protocol is simple. I've written...

Trinket Support On Linux

July 3, 2014 · claude Arduino Trinket

The Trinket (Adafruit's Trinket) can be supported on Linux using the Arduino IDE 1.0.5 in only a few steps.

How to restore the Arduino Bootloader?

July 2, 2014 · claude Linux Arduino Hardware

It can be easily done using Linux. This procedure is for the 328p processor. It can easily be adapted for a 168 processor. You will need an ICSP. First, make sure that avrdude is installed. It can be installed by issuing the command: sudo apt-get...

Mounting plate for Arduino UNO/Duemilanove/Diecimila

April 6, 2014 · claude Arduino 3D Printing

A simple mounting plate for the Arduino UNO, Duemilavone, Diecimila, Freeduino or any other compatible boards. Use #4-40 screws to mount the board on the mounting plate.

Installation of the AVR toolchain on Ubuntu to develop for the Arduino Platform

November 13, 2011 · claude Arduino Eclipse

1. Install Eclipse using "Ubuntu Software Center" 2. Install the AVR Eclipse Plugin using Help >> Install New Software. The source link is 3. Install the gcc toolchain

Tags