Antre du Tryphon

Cannot reach 110 Celsius with a Prusa PCB Heated Bed Mk 1

December 2, 2012 · claude 3D Printing Prusa Mendel

I was not able to reach 110 Celsius with a Prusa PCB Header Bed MK1. My initial installation was with the PCB traces down with a borosilicate glass on top of it. I found out that installing it with the traces up as show below resolved the issue....

G-Code commands supported by Marlin

November 29, 2012 · claude 3D Printing GCode Marlin

The G-Code commands supported by Marlin 3D printing firmware are:

Enable the TRIM command on Mountain Lion for SSD drives

November 3, 2012 · claude Mountain Lion MAC OS X

To know if TRIM is enabled for a particular drive, open "System Profiler" and search for the "TRIM enable" information in the "Serial ATA sub-tree". If TRIM is not enabled, the easiest way to enable it is to:

Building a Prusa Mendel Iteration 2 3D Printer

October 4, 2012 · claude 3D Printing

It is not obvious to choose and get a 3D printer. There is quite a lot a choices on the market which can be divided in two categories: pre-assembled and kits. Pre-assembled printers are expensive. Kits can be a quite a challenge to assemble as per...

Ralink RT5572 based WiFi Usb Dongle setup on Ubuntu 12.04

September 2, 2012 · claude Ubuntu 11.10 Ubuntu 11.04 Ubuntu +5

The WiFi USB dongles based on the newest RT5572 chip set do not work out of the box on Ubuntu. Unex DNUR-V72, D-Link DWA-160 Rev B and TP-Link TL-WDN3200 dongles are based on this chipset. You will need to compile the source code of the driver to...

2.4 GHz WiFi channels

August 16, 2012 · claude WiFI

| | | | --- | --- | | Channel | Center Frequency (GHz) | | 1 | 2.412 | | 2 | 2.417 | | 3 | 2.422 | | 4 | 2.427 | | 5 | 2.432 | | 6 | 2.437 | | 7 | 2.442 | | 8 | 2.447 | | 9 | 2.452 | | 10 | 2.457 | | 11 | 2.462 | | 12 | 2.467 | | 13 | 2.472 | | 14 |...

Recording a terminal session under Linux

August 12, 2012 · claude Ubuntu 11.10 Unix Ubuntu 11.04 +4

It is possible to record a terminal session under Linux with ttyrec. It also records vi, emacs, etc. sessions. Fisrt, install ttyrec

A step by step guide to setup a Bluetooth keyboard and mouse on the Raspberry PI

August 9, 2012 · claude Linux Debian Raspberry PI +1

A lot of people is having problem setting up a Bluetooth keyboard and mouse on the Raspberry PI. Things get more complicated when your wired keyboard or mouse does not work or prevent your Bluetooth dongle from working. There is hope. This step by...

Initializing A Wireless Connection At Boot Time

August 5, 2012 · claude Debian Raspberry PI Wheezy

You can initialize your Raspberry PI wireless connection automatically at boot time if the instructions given in a previous post entitled How To Setup A Protected Wireless Connection Via The Command-Line worked. This is pretty straight forward. You...

How To Setup A Protected Wireless Connection Via the Command-Line

August 5, 2012 · claude Unix Ubuntu Linux +3

Setting up a wireless connection via the command line may vary depending on the USB Wireless Interface you are using. These instructions also work for the Raspberry PI running Wheezy. You must be root in order to carry out these instructions. Make...

Tags