Antre du Tryphon

Mounting plate for Arduino UNO/Duemilanove/Diecimila

April 6, 2014 · claude Arduino 3D Printing

A simple mounting plate for the Arduino UNO, Duemilavone, Diecimila, Freeduino or any other compatible boards. Use #4-40 screws to mount the board on the mounting plate.

40 MM Angle Bracket With Adjustable Foot

March 10, 2014 · claude 3D Printing

This is an adjustable foot for 40 mm T-Slot aluminium extrusion combined with a 90 degree bracket. It was design, especially for a 3D printer. It can serve other purposes obviously. You will likely need 4 feet and 4 angle brackets. Furthermore, you...

40 MM T-Slot Adjustable Foot

March 7, 2014 · claude 3D Printing

This is an adjustable foot for 40 mm T-Slot aluminium extrusion. It was design, especially for a 3D printer. It can serve other purposes obviously. You will likely need 4 feet, 2 right and 2 left supports. Furthermore, you will need four threaded...

40 MM T-Slot Angle Bracket

March 4, 2014 · claude 3D Printing

40 mm T-Slot Angle Bracket.

20 MM T-Slot End Caps

March 4, 2014 · claude 3D Printing

20 mm x 20 mm, 20 mm x 40 mm and 20 mm x 60 mm T-Slot end caps.

How to use the command line to make the internal speaker beep

March 1, 2014 · claude Ubuntu 11.10 Unix Ubuntu 11.04 +2

Two simple steps: Install the beep utility. Executing beep on the command line will make the internal speaker beep. apt-get install beep Add pcspkr to /etc/modules to load it at boot time. You can load it manually by executing modprobe pcspkr

How to prevent SSHD to listen on an address family

March 1, 2014 · claude Ubuntu 11.10 Unix Ubuntu 11.04 +3

It is possible to control on which address family sshd will listen to. In /etc/ssh/sshd\_config, simply add AddressFamily any to listen to IPv4 and IPv6 addresses. This is the default. Alternatively, add one of these to listen only to IPv4 (inet) or...

Lexar USB Stick Case

February 23, 2014 · claude 3D Printing

Replacement for a Lexar USB Stick case. Cut off the support material after printing the main part of the case. Lexar's USB stick can be open easily by prying it on the side with a knife.

How to assign a static IP address in Ubuntu

February 22, 2014 · claude Ubuntu 11.10 Unix Ubuntu 11.04 +3

Setting a static IP address in Ubuntu involves editing /etc/network/interfaces. If the interface is currently using DHCP, you will find these lines in the file. auto lan iface lan inet dhcp You will have to replace the above lines with a section that...

How to change the network interface name in Ubuntu 12/13

February 22, 2014 · claude Unix Ubuntu Linux +1

Two files need to be modified to change the name of a network interface in Ubuntu. For example, if you want to change eth0 for lan, simply change the NAME attribute from eth0 to lan in these files and reboot. Do not modify the KERNEL attribute. /etc/...

Tags