Audio Selector Enclosure for 3.5 mm Jacks (November 15, 2026)
English Français
Antre du Tryphon
Search
Dual 16850 Battery Holder Mounting Plate

Dual 16850 Battery Holder Mounting Plate

November 4, 2017 · claude 3D Printing
This is a mounting plate for a Dual 16850 Battery Holder. It allows to screw the battery holder to a surface without having to put screws inside the battery holder. It prevents damages to the battery that could be made by using inner screws. The...

FlySky FS-iA6B Receiver Holder

FlySky FS-iA6B Receiver Holder

October 29, 2017 · claude 3D Printing
This is a simple holder for a FS-iA6B Radio Receiver. The holder is 49 mm wide, 12 mm in height and 10 mm deep. The mounting holes are 39 mm apart and uses M3 or #4 screws.

CR-10 X-axis Height Adjustment Tool

CR-10 X-axis Height Adjustment Tool

October 29, 2017 · claude 3D Printing
This is a X axis height adjustment tool designed for the CR-10, especially if the Z axis upgrade is installed. Nevertheless, it can be certainly used for other 3D printers. You need to print two tools to use it.

Mini and Half Breadboard Mounting Plates

Mini and Half Breadboard Mounting Plates

October 28, 2017 · claude 3D Printing
These are mounting plates for the mini and half size breadboards. Sometimes, I use a breadboard temporarily for a project. It is messy to remove it if it was sticked to a component of the project using the double sided tape underneath it. Also, it is...

Classic Arduino Mouning Plate

Classic Arduino Mouning Plate

October 22, 2017 · claude 3D Printing
This is a mounting plate for the classic Arduino's Duemilanove/Diecimila/NG/Uno and any other ones that has the same form factor. This mounting plate serves three purposes:

L298D Motor Driver Mouning Plate

L298D Motor Driver Mouning Plate

October 22, 2017 · claude 3D Printing
This is a mounting plate for the dual motors driver board that uses a L298D. They are widely available. This mounting plate serves three purposes:

CR-10 X-Axis Led Strip Holder

CR-10 X-Axis Led Strip Holder

October 15, 2017 · claude 3D Printing
This is a led strip holder that latches in the X axis extrusion slot of a CR-10 3D printer. You attach a led strip to the bottom to light up the bed while printing an object. This is a remix of http://www.thingiverse.com/thing:2252158. I removed the...

Logitech C170 Privacy Shield

Logitech C170 Privacy Shield

October 9, 2017 · claude 3D Printing
This is a privacy shield that you put on your Logitech C170 webcam in order to block the lens and thus to ensure your privacy.

Sturdy Cable Holder

Sturdy Cable Holder

October 9, 2017 · claude 3D Printing
This is a simple robust cable holder. Why robust? The other ones I designed were too weak. With time, they were bending from the weight of the cables. With 8 slots, its overall size is about 15 cm (W) x 4 cm (D) x 2.5 cm (H) or 6" (W) x 1"1/2 (D) x...

Wall Mounted Pen Cup

Wall Mounted Pen Cup

July 30, 2017 · claude 3D Printing
This is a simple pen cup that can be mounted to a wall. It is divided into three compartments of equal sizes. Its size is about 14 cm (W) x 6 cm (D) x 87 cm (H). The distance between the mounting holes is 10 cm.