Audio Selector Enclosure for 3.5 mm Jacks (November 15, 2026)
English Français
Antre du Tryphon
Search
Thickness Gauges

Thickness Gauges

December 18, 2021 · claude 3D Printing
This is a set of thickness gauges. The supplied thickness are 1, 2, 4, 8, 16 and 32 mm. Thicknesses from 1 up to 63 mm may be achieved by combining some supplied ones.

Soldering Accessories Caddy

Soldering Accessories Caddy

December 11, 2021 · claude 3D Printing
This is a small caddy to hold up to 6 soldering iron tips, up to 3 spools of solder wire and a tip cleaner.

Large DIN Rail Prototyping Stand

Large DIN Rail Prototyping Stand

December 4, 2021 · claude 3D Printing
This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also provided to tilt a bit the stand (15 degrees). You will find on Thingiverse many...

ASUS VA32A Monitor Tray System

ASUS VA32A Monitor Tray System

November 27, 2021 · claude 3D Printing
This is a tray system to be installed on the stand of an ASUS VA32A monitor.

White Board Cleaners Shelf

White Board Cleaners Shelf

November 20, 2021 · claude 3D Printing
This is a simple white board shelf for the cleaning supplies. The first holder is 9.5 cm in diameter. The second holder is 6 cm in diameter. Two 5 mm mounting screw holes are provided.

SBC Server Case V2

SBC Server Case V2

November 12, 2021 · claude 3D Printing
This is a modular Single Board Computers enclosure for up to 4 devices. The device cards are held vertically. This design let you service one card without having to remove the cards on top of it like in the previous design (https://www.thingiverse.co...

White Board Organizer V2

White Board Organizer V2

November 6, 2021 · claude 3D Printing
This simple white board organizer can hold 6 markers along with the eraser.

Wera Micro Screwdriver Stackable Tray

Wera Micro Screwdriver Stackable Tray

October 23, 2021 · claude 3D Printing
This is a tray that holds up to 8 Wera micro screwdrivers. The design will hold the screwdriver labels upright. Multiple trays may be stacked. Support material is required for the corners. An infill of 20% is recommended.

What performance to expect using a Raspberry Pi as a firewall?

What performance to expect using a Raspberry Pi as a firewall?

October 2, 2021 · claude Raspberry PI Raspbian RaspberryPI +2
I've tested 3 different Raspberry Pi used as firewalls at measured the performance I was getting. The Raspberry Pis are:

Micro SD Card Carrier

Micro SD Card Carrier

September 25, 2021 · claude 3D Printing
This object is a simple micro SD card carrier having the same size as an SD card. It was designed to put a micro SD card into a SD card case that contains sleeves.