Antre du Tryphon

Tactical Strike Ammunition Reservoir Extension

January 28, 2018 · claude 3D Printing

This is an ammunition magazine extension for the Tactical Strike (Adventure Force). It is like a Nerf gun except that the ammunition is balls.

Fume Extractor V2

December 27, 2017 · claude 3D Printing

This fume extractor uses carbon filters of 130mm x 130mm x 10mm. These are used for the HAKKO 491/493 fume extractor. To build it, you'll need:

Power Supply Mounting Brackets

December 3, 2017 · claude 3D Printing

These are "Mean Well" type power supply mounting brackets. You will be able to mount this type of power supply on a surface using screws. This bracket is quite sturdy. The slot on the bracket that holds the power supply supports up to M4 screws. It...

Dual 16850 Battery Holder Mounting Plate

November 4, 2017 · claude 3D Printing

This is a mounting plate for a Dual 16850 Battery Holder. It allows to screw the battery holder to a surface without having to put screws inside the battery holder. It prevents damages to the battery that could be made by using inner screws. The...

FlySky FS-iA6B Receiver Holder

October 29, 2017 · claude 3D Printing

This is a simple holder for a FS-iA6B Radio Receiver. The holder is 49 mm wide, 12 mm in height and 10 mm deep. The mounting holes are 39 mm apart and uses M3 or #4 screws.

CR-10 X-axis Height Adjustment Tool

October 29, 2017 · claude 3D Printing

This is a X axis height adjustment tool designed for the CR-10, especially if the Z axis upgrade is installed. Nevertheless, it can be certainly used for other 3D printers. You need to print two tools to use it.

Mini and Half Breadboard Mounting Plates

October 28, 2017 · claude 3D Printing

These are mounting plates for the mini and half size breadboards. Sometimes, I use a breadboard temporarily for a project. It is messy to remove it if it was sticked to a component of the project using the double sided tape underneath it. Also, it is...

Classic Arduino Mouning Plate

October 22, 2017 · claude 3D Printing

This is a mounting plate for the classic Arduino's Duemilanove/Diecimila/NG/Uno and any other ones that has the same form factor. This mounting plate serves three purposes:

L298D Motor Driver Mouning Plate

October 22, 2017 · claude 3D Printing

This is a mounting plate for the dual motors driver board that uses a L298D. They are widely available. This mounting plate serves three purposes:

CR-10 X-Axis Led Strip Holder

October 15, 2017 · claude 3D Printing

This is a led strip holder that latches in the X axis extrusion slot of a CR-10 3D printer. You attach a led strip to the bottom to light up the bed while printing an object. This is a remix of http://www.thingiverse.com/thing:2252158. I removed the...

Tags