Antre du Tryphon

FLsun Cube X Axis Motor Wire Guide

September 28, 2019 · claude 3D Printing

This is a simple X-Axis motor wire guide for the FLsun Cube. It is mounted using one of the screws of the linear bearing of the Y-Axis.

2020 Extrusion Mosfet Holder

September 21, 2019 · claude 3D Printing

This is a Mosfet board holder that is made to be mounted on a 2020 extrusion. It has been specifically designed for a FLsun Cube.

2020 Extrusion Spool Holder

September 15, 2019 · claude 3D Printing

This spool holder is designed to fit a 2020 aluminum extrusion. It is a replacement for the FLSun Cube spool holder.

This a part that is installed on the existing feet of the FLsun Cube. The stock feet made of aluminum damage the surface of the table on which the printer is installed. These will protect your work area.

FLSun Cube Bowden Tube Strain Relief

August 31, 2019 · claude 3D Printing

This is a Bowden tube strain relief for the FLsun Cube. It should be installed near the extruder.

Reprap Discount LCD Holder for 2020 extrusion

August 24, 2019 · claude 3D Printing

This Reprap Discount LCD holder has been specially designed for the FLSun Cube. This design lets you attach the display under a 2020 extrusion.

FLSun Cube X-Axis Belt Tensioner

August 18, 2019 · claude 3D Printing

The FLSun Cube 3D printer does not come with an X-Axis belt tensioner. So, I designed one. The design is simple but very effective.

FLSun Cube Bed Level Adjustment Tool

August 10, 2019 · claude 3D Printing

This is a simple tool to adjust the level of the bed of a FLSun Cube. Likely, it can be used with other printers such as the CR-10.

FLSun Cube Bed Cable Strain Relief

August 3, 2019 · claude 3D Printing

This is a strain relief for the heated bed cables of the FLSun Cube. A zip tie is used to fix it to the bed frame. I drilled a small hole to pass the zip tie through the bed frame.

FLSun Cube Extruder Cable Strain Relief/Holder i2

July 27, 2019 · claude 3D Printing

This is a strain relief for the wires and the PTFE tube attached to the extruder of the FLSun Cube 3D printer. It is installed using the bolts of 2 of the linear bearing holders. The M4x16 bolts will need to be replaced by M4x20 bolts. A zip tie is...

FLsun Cube X Axis Motor Wire Guide

2020 Extrusion Mosfet Holder

2020 Extrusion Spool Holder

FLSun Cube Foot

FLSun Cube Bowden Tube Strain Relief

Reprap Discount LCD Holder for 2020 extrusion

FLSun Cube X-Axis Belt Tensioner

FLSun Cube Bed Level Adjustment Tool

FLSun Cube Bed Cable Strain Relief

FLSun Cube Extruder Cable Strain Relief/Holder i2

Tags