Antre du Tryphon

How to prevent SSHD to listen on an address family

March 1, 2014 · claude Ubuntu 11.10 Unix Ubuntu 11.04 +3

It is possible to control on which address family sshd will listen to. In /etc/ssh/sshd\_config, simply add AddressFamily any to listen to IPv4 and IPv6 addresses. This is the default. Alternatively, add one of these to listen only to IPv4 (inet) or...

Lexar USB Stick Case

February 23, 2014 · claude 3D Printing

Replacement for a Lexar USB Stick case. Cut off the support material after printing the main part of the case. Lexar's USB stick can be open easily by prying it on the side with a knife.

How to assign a static IP address in Ubuntu

February 22, 2014 · claude Ubuntu 11.10 Unix Ubuntu 11.04 +3

Setting a static IP address in Ubuntu involves editing /etc/network/interfaces. If the interface is currently using DHCP, you will find these lines in the file. auto lan iface lan inet dhcp You will have to replace the above lines with a section that...

How to change the network interface name in Ubuntu 12/13

February 22, 2014 · claude Unix Ubuntu Linux +1

Two files need to be modified to change the name of a network interface in Ubuntu. For example, if you want to change eth0 for lan, simply change the NAME attribute from eth0 to lan in these files and reboot. Do not modify the KERNEL attribute. /etc/...

Simple, Yet Stylish Phone Stand Printable Rods

February 16, 2014 · claude 3D Printing

Printable rods for Simple, yet stylish phone stand. Length is 50 mm, 10 mm in diameter.

605ZZ Bearing Mockup

February 16, 2014 · claude 3D Printing

605ZZ Bearing Mockup.

40 Mm Fan Deflector

February 16, 2014 · claude 3D Printing

40 mm fan deflector compatible with Misan's Another Compact Extruder Fan Holder.

Power Outage Protection for 3D printers

January 4, 2014 · claude 3D Printing

This device is a protection against power outage for a 3D printer. If the power goes out, the printer will not be turned back on when the power comes back. The scenario I have experienced is the following. I was printing an object using a laptop....

Simple Spool Bushing V2

December 31, 2013 · claude 3D Printing

These spool bushings are simple. Use one or two elastic bands to install them on a spool. Nothing else is required. The center hole of the bushing is for a 1/4" smooth rod. It can be easily increased with a drill bit. I have supplied spool bushing of...

Print Bed Center Marker

December 29, 2013 · claude 3D Printing

This object helps in the calibration of the center of your print bed. Its overall size is 30 mm x 30 mm x 2 mm in height.

Tags