Antre du Tryphon

Logitech C170 Privacy Shield

October 9, 2017 · claude 3D Printing

This is a privacy shield that you put on your Logitech C170 webcam in order to block the lens and thus to ensure your privacy.

This is a simple robust cable holder. Why robust? The other ones I designed were too weak. With time, they were bending from the weight of the cables. With 8 slots, its overall size is about 15 cm (W) x 4 cm (D) x 2.5 cm (H) or 6" (W) x 1"1/2 (D) x...

Wall Mounted Pen Cup

July 30, 2017 · claude 3D Printing

This is a simple pen cup that can be mounted to a wall. It is divided into three compartments of equal sizes. Its size is about 14 cm (W) x 6 cm (D) x 87 cm (H). The distance between the mounting holes is 10 cm.

Suspended Glass For Photography - 1-1/4 Inch Pipe Foot

May 15, 2017 · claude 3D Printing

This model can be used for many purposes. Nevertheless, it was mainly designed to suspend a sheet of glass in the air. This setup is used to take pictures of small objects without shadows. This object is designed for standard 1-1/4 inch abs drain...

Rigid 18V Vacuum Nozzle

May 15, 2017 · claude 3D Printing

This is a simple wide nozzle for a Rigid Gen5X Brushless 18V Wet/Dry Vacuum. The internal diameter is about 31.5 mm or 1-1/4 inch.

How to install Pronterface on Ubuntu 16.04

April 29, 2017 · claude Ubuntu 3D Printing

To install Pronterface on Unbuntu, first install the dependencies.

How to remove permanently an object in GIT

April 14, 2017 · claude GIT

To remove permanantly an object in a remote GIT repository, simply perform these steps. Prior executing them, go to the GIT project folder. This is the one having the .git folder.

Case for the GM328A Components Tester

March 7, 2017 · claude 3D Printing

This object is a case for the GM328A Electronic Components Tester. It has a compartment for the 9V battery and an access hole for the extra test leads. The thin plate on the battery cover should be placed between the Component Tester and the battery...

Prusa i3 Simple LCD Holder

March 6, 2017 · claude 3D Printing

This is a simple Reprap character based LCD holder for a Prusa i3 3D printer. It is designed to be attached to a 6.35 mm tick frame, 45 mm in length. To mount this holder on the frame, you will need: - 1 x M3 25 mm screw with its nut - 1 x M3 16 mm...

Parametric Screw to Zip Tie Adapter

July 24, 2016 · claude 3D Printing

This is a simple parametric adapter that lets you mount a device designed for screws with a Zip Tie. You do not need to make holes in the thing holding the device.

Logitech C170 Privacy Shield

Sturdy Cable Holder

Wall Mounted Pen Cup

Suspended Glass For Photography - 1-1/4 Inch Pipe Foot

Rigid 18V Vacuum Nozzle

How to install Pronterface on Ubuntu 16.04

How to remove permanently an object in GIT

Case for the GM328A Components Tester

Prusa i3 Simple LCD Holder

Parametric Screw to Zip Tie Adapter

Tags