Antre du Tryphon

Ender Z End-Stop Spacer

October 14, 2018 · claude 3D Printing

Put this spacer between the X-Axis and the Z end-stop. It is useful when adding a 3 mm glass on the bed of an Ender-2 or Ender-3 3D printer. It is a lot easier to use this spacer than to move the Z end-stop up. A drop of hot glue is used to maintain...

Power Supply Fan Deflector

October 8, 2018 · claude 3D Printing

This is a simple power supply fan deflector to redirect the air flow. A few drops of hot glue is used to install it.

PTFE Tube Cutting Guide

September 30, 2018 · claude 3D Printing

These are 4mm and 6mm PTFE tube cutting guides. Use a very sharp razor blade.

Twin Deep Buckets for Ikea Ivar Shelving System

September 23, 2018 · claude 3D Printing

These are deep twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 8 cm (D). Support is needed. Infill of 20% or above is suggested.

Twin Deep Partitionned Buckets for Ikea Ivar Shelving System

September 16, 2018 · claude 3D Printing

These are deep partitioned twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 8 cm (D). Support is needed. Infill of 20% or above is suggested.

Twin Small Buckets for Ikea Ivar Shelving System

September 10, 2018 · claude 3D Printing

This is twin small buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 4 cm (D). Support is needed. Infill of 20% or above is suggested.

Ikea Ivar Brackets for 19 Inches Rack Mount Devices

September 3, 2018 · claude 3D Printing

This is a bracket for 19 inches rack mount devices. You will need to print each file two times. You will need the following hardware to attach the bracket on the Ivar side unit.

TRENDnet TK-207K KVM Holder for Ikea Ivar

August 27, 2018 · claude 3D Printing

This is a holder for a TRENDnet TK-207K KVM. The holder is hanged on a unit side of the Ikea Ivar shelving system. The TRENDnet TK-207K is a 2 ports Keyboard/Video/Mouse switch.

Ivar FlashLight Holder 2

August 19, 2018 · claude 3D Printing

This is a flashlight holder who is installed on the side unit of the Ivar shelving system. The hole holding the flashlight is 4.5 cm in diameter. It fits flashlight that uses D-cell batteries. You will also need 2 #4-40, 3/8" bolts and the matching...

Ikea Ivar Small Bucket

August 12, 2018 · claude 3D Printing

This is a small bucket to be hanged on the side unit of the Ikea Ivar shelving system. The bucket is 12.5 cm (L) x 4 cm (W) and 4 cm (D). Support is needed. Infill of 20% or above is suggested.

Tags