Audio Selector Enclosure for 3.5 mm Jacks (November 15, 2026)
English Français
Antre du Tryphon
Search
Ivar Side Unit Pin Hook

Ivar Side Unit Pin Hook

February 23, 2020 · claude 3D Printing
This is a small pin design to hang stuff on the vertical post of Ikea Ivar side units. The pin is 3mm in diameter, 10 mm long.

Zip Tie Sleeves for the Ivar System

Zip Tie Sleeves for the Ivar System

February 17, 2020 · claude 3D Printing
This is a sleeve for Zip Ties. Its main utility is to protect the vertical supports of the Ikea Ivar system when using Zip Ties to attach stuff. They support zip ties up to 5 mm wide.

EN-EL10 Battery Tray

EN-EL10 Battery Tray

January 18, 2020 · claude 3D Printing
This is two battery tray design for the EN-EL10 batteries. They are used by Nikon for their point and shoot cameras. One of the design holds 6 batteries while the other one holds 4 batteries at an angle for a lower overall height.

IN-12B Nixie Tube Storage Tray

IN-12B Nixie Tube Storage Tray

January 11, 2020 · claude 3D Printing
This is a storage tray designed to hold 12 IN-12 Nixie Tubes. Each compartment is 30.5mm x 20.5mm x 20mm in height.

Stanley Picks and Hooks Pegboard Holder

Stanley Picks and Hooks Pegboard Holder

January 4, 2020 · claude 3D Printing
This is a simple holder for the set of 4 Picks and Hooks made by Stanley. It is designed for the north American pegboard. The holes are 1 inch (25.4 mm) apart.

Alligator Clip Cable Pegboard Holder (updated)

Alligator Clip Cable Pegboard Holder (updated)

December 30, 2019 · claude 3D Printing
It can hold up to 20 alligator clip cables. It is designed to be used with a North American pegboard. The distance between the holes is 1 inch (2.54 cm). The hole diameter is 1/4 of an inch (6.35 mm).

Parametric Open Box

Parametric Open Box

December 22, 2019 · claude 3D Printing
This is a simple SCAD file that generates simple open boxes without chamfers or fillets. They fit snuggly together. A sample is included. To create a custom one:

Ivar Side Unit Hook

Ivar Side Unit Hook

December 16, 2019 · claude 3D Printing
This is a simple Ivar Side Unit hook. No additional hardware is required.

FLSun Cube Part Cooling Fan

FLSun Cube Part Cooling Fan

December 2, 2019 · claude 3D Printing
This is a part cooling fan for the FlSun. The original design has only one fan that cools the extruder and the part at the same time but it doesn't do a good job.

Flsun Cube Nozzle Cooling Duct

Flsun Cube Nozzle Cooling Duct

November 24, 2019 · claude 3D Printing
These objects replace the poor stock nozzle cooling system provided by FLsun. You will need 2 x M3-20 mm bolts and nuts to mount the fan along with the fan grid.