Antre du Tryphon

DIN Rail Prototyping Stand

May 23, 2021 · claude 3D Printing

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. In the picture, the bottom part of the stand is 20 mm higher than the height in the supplied STL file....

4 Digits Nixie Tube Clock Stand

April 25, 2021 · claude 3D Printing

This is a 15 mm in height stand for a 4 Digits Nixie Tube Clock. This clock is available on AliExpress. The base of the clock is 40 mm x 111 mm.

Another Pen Holder

April 17, 2021 · claude 3D Printing

This is a pen holder of an unusual design. Three sizes are available. You can increase the capacity of them by gluing another one on its side.

How to move a directory from one git repository to another one preserving the history

April 10, 2021 · claude GIT

These simple steps will let you move a directory contained within a git repository into another one while preserving the history.

Waveshare Pi Pico Dual Expander Base Plate

April 10, 2021 · claude 3D Printing

This is a baseplate for the Waveshare Pi Pico Dual Expander. You will need 4 tiny screws to mount it. An infill of 15% is recommended. Support is not needed.

1802 Membership Card Stand

February 26, 2021 · claude 3D Printing

This is a simple stand for the 1802 (COSMAC ELF) Membership Card. The 1802 is a vintage micro-processor. You can get this kit at http://www.sunrise-ev.com/1802.htm . I'm not affiliated with the seller in anyway. I bought the kit.

LG 27EA33 Storage Trays

February 21, 2021 · claude 3D Printing

This is a tray designed to be installed on the stand of an LG 27EA33 monitor. You need to print the STL file provided and the same file mirrored. You will then need to glue them together.

Panavise 303 replacement pads

January 24, 2021 · claude 3D Printing

These are replacement pads for the Panavise 303 vise. It has groves to hold tubular objects. I've printed it in semi-flexible filament, but works fine printed in PLA.

SBC Server Case

December 28, 2020 · claude 3D Printing

This is a modular SBC or Development Board enclosure. Its base design principle is you stack on top of each other plates that hold various devices such as Raspberry PI, Arduinos, ESP32, hard drives, etc. You can customize it the way you like. You may...

3.5 inch Hard Drive Box

November 8, 2020 · claude 3D Printing

This is a box for a 3.5 inch hard drive and its cover. It was specifically designed to fit in a small safety box often rented by banks.

Tags