Antre du Tryphon

7 ways to kill your startup

September 2, 2023 · claude Management

Focus on fundraising above all else. Grow your team faster than your revenue. Pretend you’re a big company and act like one. Sell a dollar for 90 cents, so you can ramp up growth. Whenever you have a problem, throw some money at it. Mistake being...

Parametric Clickable Stamps Holder

July 28, 2023 · claude 3D Printing

Parametric Clickable Stamp Holder. It fit out of the box, the stamps distributed by Michaels'. The item numbers of these stamps are 10656553 and 10656558. Holder for 3 to 9 stamps are included as the base set. You can customize the holder to fit any...

Ikea Ivar Caliper and Folding Ruler holder

July 22, 2023 · claude 3D Printing

This is a holder for a Caliper and Folding Ruler for the Ikea Ivar. It is designed for the side units. The width of the folding ruler is 1.6 cm. The width of the caliper with its case is 2.8 cm.

Parametric Clickable Stamp Case

July 15, 2023 · claude 3D Printing

This is a parametric clickable stamps case. It fit out of the box the stamps distributed by Michaels'. The item numbers of these stamps are 10656553 and 10656558.

Triple 5mA battery trickle charger

July 7, 2023 · claude 3D Printing

Triple 5mA battery trickle charger --------------------------------------------------------------------------------

Pen Holder V05

June 30, 2023 · claude 3D Printing

This is another variation of the pen holder published previously. This one is the largest. It can hold about 64 pens. The top part of it is modular. It can be redesigned and printing the whole pen holder is not required. The current version can hold...

Parametric Container with an overlapped lid

June 24, 2023 · claude 3D Printing

This is a parametric container with an overlapped lid.

8 ml Inkwell

June 10, 2023 · claude 3D Printing

This is a small 8 ml inkwell design to be used to refill a fountain pen. Test it with water before putting ink in it. Printing parameters may prevent it from being water tight.

Parametric Stamp Handle

April 29, 2023 · claude 3D Printing

This is a parametric stamp handle. It works pretty well with silicon stamps. I've used superglue to attach the stamp to the handle. A sample STL file is provided. Use OpenSCAD to create one that fits the dimensions you need.

Simple human interface for Home Assistant

April 22, 2023 · claude Hardware 3D Printing Automation +5

This is a simple human interface project for Home Assistant. It helps me remind doing 2 daily tasks. Using Home Assistant automation, it lit a LED at a given time and use the corresponding button to reset it when I'm done.

Tags