Terminal Block Holder for Aluminium Extrusion (March 3, 2015)
English Français
Antre du Tryphon
Back to Posts

Terminal Block Holder for Aluminium Extrusion

March 3, 2015 · claude 3D Printing
Terminal Block Holder for Aluminium Extrusion
Terminal Block Holder for Aluminium Extrusion Terminal Block Holder for Aluminium Extrusion Terminal Block Holder for Aluminium Extrusion

Description

These are simple terminal block holders for Misumi aluminium extrusion (or equivalent). There is a 3 to 4 mm space between the extrusion and the terminal block to run some wires.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

Leave a Comment

Replying to
Your email address will not be published.

Copyright 2012–2026, Claude "Tryphon" Théroux