Power Supply Fan Deflector (October 8, 2018)
English Français
Antre du Tryphon

Power Supply Fan Deflector

October 8, 2018 · claude 3D Printing
Power Supply Fan Deflector

Power Supply Fan Deflector Power Supply Fan Deflector Power Supply Fan Deflector

Description

This is a simple power supply fan deflector to redirect the air flow. A few drops of hot glue is used to install it.

Support is not required. Simply print it upside down.

This object was designed using Fusion 360


Files


This object is also published on the following site(s):


This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.


Leave a Comment

Replying to
Your email address will not be published.

Copyright 2012–2026, Claude "Tryphon" Théroux