Power Brick Holder

February 16, 2019 · claude 3D Printing

Description

This is a holder for a power brick of 18 cm (7 inches) in length, 4.5 cm (1 3/4 inch) tick and typically 7 cm (2 3/4 inches) in height. Nevertheless, it can be lower or higher.

No support is needed.

This object was designed using Fusion 360

Files

Power-Supply-Holder.stl

This object is also published on the following site(s):

Thingiverse

Power Brick Holder (213)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

Comments

Timothy P. Earls October 10, 2025

Great design!
Looking for source file to adjust size. Thanks!

ctheroux October 16, 2025

Hi, you will receive shortly an email with the source file. Regards.

Pangolin Chang August 25, 2025

Great design. Do you mind sharing the source file? Want to lower the height in the front.

Dmitry Serebrianik June 4, 2023

Hi

Can I please have source files for your power brick design..Looks awesome

thanks

ctheroux June 4, 2023

Hi,

you'll shortly receive a link to download the source file.

Regards

Tom McGeehan October 24, 2021

Hello. This is a great design. May I please have the source files? I would like to update it to fit the transformer I have. Thank you.

ctheroux October 24, 2021

Hi, you will receive shortly a link to download the source file. Regards, Claude

Power Brick Holder

Description

Files

This object is also published on the following site(s):

Comments

Leave a Comment