Ivar FlashLight Holder 1
English · Français
August 6, 2018
Antre du Tryphon

Ivar FlashLight Holder 1

August 6, 2018 3D Printing object
Ivar FlashLight Holder 1

Ivar FlashLight Holder 1 Ivar FlashLight Holder 1 Ivar FlashLight Holder 1

Description

This is a flashlight holder that is installed on the side unit of the Ivar shelving system. The hole that holds the flashlight 4.5 cm in diameter. It fits flashlight that uses D cell batteries.

An infill of 40% is recommended.

They can be printed without support.

This object was designed using Fusion 360


Files

Ivar-FlashLight-Holder-1.stl Ivar-FlashLight-Holder-1.stl

This object is also published on the following site(s):


This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.


Leave a Comment

Replying to
Your email address will not be published.

Copyright 2012–2026, Claude "Tryphon" Théroux