Ikea Vattenkar Zip Tie Hooks (October 10, 2025)
English Français
Antre du Tryphon

Ikea Vattenkar Zip Tie Hooks

October 10, 2025 · claude 3D Printing
Ikea Vattenkar Zip Tie Hooks

Ikea Vattenkar Zip Tie Hooks Ikea Vattenkar Zip Tie Hooks Ikea Vattenkar Zip Tie Hooks

Description

These are 2 sizes of zip tie hooks to hang an object under the shelves of an Ikea Vattenkar. You need to print a pair of hooks. You hang them on the opposite sides of a shelf and pass a zip tie in the lower holes.

Support material is not required. An infill of 25% is recommended.

This object was designed using Solid Edge Community Edition.


Files


This object is also published on the following site(s):


This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.


Leave a Comment

Replying to
Your email address will not be published.

Copyright 2012–2026, Claude "Tryphon" Théroux