Case for the GM328A Components Tester (March 7, 2017)
English Français
Antre du Tryphon
Back to Posts

Case for the GM328A Components Tester

March 7, 2017 · claude 3D Printing
Case for the GM328A Components Tester
Case for the GM328A Components Tester Case for the GM328A Components Tester Case for the GM328A Components Tester Case for the GM328A Components Tester

Description

This object is a case for the GM328A Electronic Components Tester. It has a compartment for the 9V battery and an access hole for the extra test leads. The thin plate on the battery cover should be placed between the Component Tester and the battery to prevent any short circuits. 6 screws such as M3 x 12mm are required. Similar screws will also fit.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

Leave a Comment

Replying to
Your email address will not be published.

Copyright 2012–2026, Claude "Tryphon" Théroux