4 inches x 0.7 inches Label Holder

March 20, 2020 · claude 3D Printing

Description

This is a paper tag holder made out of 4 inches (10.1 cm) x 3 inches (7.6 cm) index cards. They fit an edge of about 1/4 (6.25 mm) of an inch wide. A piece of size 4 inches (10.1 cm) x 0.7 (1.75 cm) inch out of the index card fits well.

No support is needed if printed upright. It is the same orientation as the one in the main picture. You will have to rotate the object on the build plate during the slicing process.

This object was designed using Fusion 360

Files

	Project-Box-Label-Holder-6mm.stl
	Project-Box-Label-Holder-6.5mm.stl
	Project-Box-Label-Holder-7mm.stl

This object is also published on the following site(s):

Thingiverse

4 inches x 0.7 inches Label Holder (256)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

4 inches x 0.7 inches Label Holder

Description

Files

This object is also published on the following site(s):

Leave a Comment